Using DCT4/WD2/TIKU RPL Service with F1 device
Selecting Flash files:
Please select the flash files from Product box - currently RH-18 Nokia 1100a
You will see the following screen.
Type the password you have for your account in “Server pass” field. If you do not want the password to be saved then tick “Do not save password”.
Click “Read” button and the phone will be set in boot mode to get UEM IMEI which is needed for Flash Data1 repair calculation. You will see the following screen.
Uploading the file:
Now click “Load RPL File” button and the software will connect to our server and upload the RPL file for your phone. At the same time it will save a backup of this RPL file for later use.
FLS: — Reading HW details -
FLS: Setting speed…
FLS: Sucess. Booting…
FLS: ->FBUS Comm ok.
FLS: ->Bootrom test ok.
FLS: Bootrom Version: 0×1201
FLS: Bootrom Type: 2
FLS: ->RAM test ok.
FLS: ->CBUS test ok.
FLS: BCD IMEI:33657601300162F1
FLS: UEM IMEI:356671003102610
FLS: — Finished -
NSS: Checking data…Done.
NSS: Connecting to Server…Done.
NSS: Nss Server Version 0.0.0.6
NSS: TDS6Module Version 0.0.0.5
NSS: Your credit is 95
NSS: Calculating DATA…Done.
NSS: Session End.
NSS: Preparing…Done.
FLS: DCT4 - Boot in Flash Mode.
FLS: Reading MCU file: rh18_05.620
FLS: Done. Set speed.
FLS: Sending bootloader: u_2nd.fia
FLS: Asic: 0×1201
FLS: Number of IDs: 1
FLS: Dev0: 0×00208823
FLS: Base: 0×01000000, Sector Size: 0×10
FLS: Sending Algorithm: u_st_i.fia
FLS: Performing Authentification.
FLS: UEM Rev: 0×53
FLS: — Success -
NSS: Writing: 356671003102610c.rpl
FLS: Open rpl file…
FLS: Done.
FLS: Write to Flash…
FLS: Write to Flash finished.
FLS: DCT4 - Restart MCU
FLS: Restart Success.
This is a full log of the procedure
If you want to repair the same phone, but you have connected one time to our server, you have the RPL file on backup, so you can use it.
You have to tick “Use RPL file” and when you click “Load RPL File” button, you will be asked to select the RPL file you want to upload.
When you open the file, the phone will be set in boot mode and the data will be written to the phone.
That’s it.